复溶 retatrutide 小瓶:计算方法
冻干研究用小瓶的四个步骤、三个计算示例以及一个计算器。仅为实验台上的计算,不构成用药指导。
5 分钟阅读 · 2026-11-17
冻干研究用小瓶的四个步骤、三个计算示例以及一个计算器。仅为实验台上的计算,不构成用药指导。
5 分钟阅读 · 2026-11-17
复溶是指向冻干(冷冻干燥)产品中加入稀释剂,使其重新溶解成溶液 13。retatrutide 研究用小瓶以密封小瓶中的冻干粉末形式供应。
这一计算无需引用来源。浓度等于小瓶中的质量除以所加入的体积。容纳某一质量所需的体积,等于该质量除以浓度。
从粉末到测量好的样品
对任何冻干小瓶都是同样的四个步骤。仅指实验室操作,并非用于人体。
1. 阅读小瓶标签
标签给出小瓶中肽的质量,单位为毫克。这个数字是所有计算的起点。
2. 加入稀释剂
将量好的稀释剂沿玻璃壁缓慢加入。轻轻旋转;摇晃可能损伤肽。
3. 计算浓度
浓度等于质量除以体积:10 毫克溶于 2 毫升即为每毫升 5 毫克。
4. 量取样品
体积等于所需质量除以浓度。在 U-100 注射器上,1 毫升即 100 单位。
10 mg 小瓶加入 2 mL 稀释剂,浓度为每 mL 5 mg。则 1 mg 样品体积为 0.2 mL,在 U-100 注射器上读数为 20 单位。
20 mg 小瓶加入 2 mL,浓度为每 mL 10 mg。4 mg 样品体积为 0.4 mL,即 40 单位。
同样是30 mg装于3 mL的小瓶,浓度即为每毫升10 mg。12 mg的样品需要取1.2 mL,超过1 mL注射器的容量。因此稀释液的体积需结合样品量来选择:稀释液越少,溶液浓度越高,需要量取的体积也越小。
The amounts in these examples are weekly amounts that the phase 2 protocols assigned to trial arms 12. They are used so the arithmetic can be checked against the published studies. They are not a recommendation of any kind.
Draw to
10 units
0.1 mL on a U-100 syringe
20 mg in 2 mL is 10 mg/mL. 1 mg of that is 0.1 mL, which reads as 10 units. This is arithmetic for a vial of Retatrutide; no amount here is a recommendation.
冻干肽的一般做法是将密封小瓶冷冻或冷藏,保持干燥并避光,并遵循供应商的分析证书。试验报告未描述视黄肽自身试验供应品的保存方式。
肽复溶后应冷藏保存,并在供应商规定的期限内使用。若小瓶需要多次抽取,则需使用含防腐剂的稀释液13。
The numbers are those of the Retatrutide page, where every source is listed.