Skip to the page
pepts.wiki

We are not doctors and nothing here is medical advice. Always consult a medical professional first. Why we say this

Guides

How reconstitution works

What happens when diluent meets a lyophilized cake, and the arithmetic that turns a vial into a concentration.

5 min read · 2026-11-16

The cake in the vial

Peptides are unstable in water over months, so they are shipped dry. Lyophilization, or freeze-drying, removes the water from a frozen solution under vacuum and leaves a porous cake or a film on the glass. The cake often looks far smaller than its label suggests: a few milligrams of peptide is a small amount of matter, and bulking agents make up most of what is visible.

Reconstitution is adding a diluent back so the cake dissolves into a solution that can be measured by volume.

The arithmetic

Concentration is the mass in the vial divided by the volume added. A 10 mg vial with 2 mL of diluent is 5 mg/mL. The volume that holds a smaller mass is that mass divided by the concentration: 1 mg of that solution is 0.2 mL.

A U-100 insulin syringe marks one milliliter as 100 units, so 0.2 mL reads as 20 units. A unit on that scale is a volume, 0.01 mL, and never a mass: how many micrograms it holds depends entirely on how much diluent went into the vial.

Adding less diluent makes a stronger solution and smaller volumes to measure; adding more makes a weaker one that is easier to read accurately. The calculator works this out for any vial.

Which diluent

Bacteriostatic water is sterile water with 0.9% benzyl alcohol, a preservative that stops bacteria multiplying in a vial that is drawn from more than once. Sterile water has no preservative and suits a vial used once. A few peptides dissolve poorly in plain water and are reconstituted in dilute acetic acid; the supplier's sheet says when.

Diluent is run slowly down the inside wall of the vial rather than squirted onto the cake, and the vial is swirled gently, not shaken: vigorous shaking can make peptides clump and foam.

From powder to a measured sample

The same four steps for any lyophilized vial. Laboratory handling, not use in a person.

  1. 1. Read the vial

    The label gives the mass of peptide in the vial, in milligrams. That number is the start of every calculation.

  2. 2. Add the diluent

    A measured volume of diluent goes in slowly, down the glass. Swirl gently; shaking can damage a peptide.

  3. 3. Work out the strength

    Concentration is mass divided by volume: 10 mg in 2 mL is 5 mg per mL.

  4. 4. Measure the sample

    Volume is the mass wanted divided by the concentration. On a U-100 syringe, 1 mL is 100 units.

Try it

Draw to

5 units

0.05 mL on a U-100 syringe

Concentration
5 mg/mL
Each unit holds
50 mcg
Samples in the vial
40
Sample
250 mcg

10 mg in 2 mL is 5 mg/mL. 250 mcg of that is 0.05 mL, which reads as 5 units. Arithmetic only: no amount here is a recommendation.

Read next